Using the Web to change the administrator's Web password

This section describes how to use the Tape Library Specialist Web interface to change an administrator's Web password.

About this task

Only an administrator can use this procedure to change the administrator's password to the Tape Library Specialist Web interface.
Note: This page is not available if the Storage Authentication Service is enabled.

To use the Tape Library Specialist Web interface to change the administrator's password, perform the following steps:

Procedure

  1. From the Work Items navigation pane, select Access > Web Security.
    The Web Security screen displays.
  2. At the Password Protection tab, select Enabled.
  3. Select the desired settings for each of the Password Policies. See Table 1.
  4. Select Apply.
    A pop-up box displays where you can type the User ID and Password.
  5. Enter admin for the User ID, then enter the Web password that the library assigned.
  6. Select Apply.
    The screen displays the message Password protection is enabled.
  7. Select Access —> Change Web Password.
    The Change Web Password screen displays.
  8. Enter admin for the User ID, the current Web password, new Web password, and the new Web password again for confirmation. Select Apply.
    A pop-up window displays the message The password change is complete.
  9. Select Apply to close the pop-up window.