HD68347: STCAI : CGR CREATED NOT CONSISTENT WITH DATA IN THE VAULT

APAR status

• Closed as Permanent restriction.

Error description

• STCAI : cgr created not consistent with data in the
  vault
  .
  Smarteam CATIA integration problem reproduced
  on SmDemo
  .
  Scenario :
  1. Start CATIA. Connect to Smarteam as 'joe'.
  2. Open the provided
  CATProduct 'Viewer.CATProduct'.
  3. Save and Check in 'Viewer.CATProduct' in
  Smarteam.
  4. Open the checked in part 'Rectangle.CATPart'.
  Release it.
  5. Open for edit 'Viewer.CATProduct'
  6. Do a modification of the released
  part 'Rectangle.CATPart'. Say 'no' to the COOF
  message. (part is dirty)
  7. Check in the CATProduct 'Viewer'. (say Ok to
  the message about the dirty part)
  Problem : The cgr created for the
  CATProduct 'Viewer' shows the modification in
  the 'Rectangle' part. (this can be checked by
  opening the cgr in CATIA or by using the
  Smarteam viewer)
  It's not consistent with the CATProduct in the vault
  .
  

Local fix

Problem summary

• STCAI : cgr created not consistent with data in the vault
  STCAI : cgr created not consistent with data in the
  vault
  .
  Smarteam CATIA integration problem reproduced
  on SmDemo
  .
  Scenario :
  1. Start CATIA. Connect to Smarteam as 'joe'.
  2. Open the provided
  CATProduct 'Viewer.CATProduct'.
  3. Save and Check in 'Viewer.CATProduct' in
  Smarteam.
  4. Open the checked in part 'Rectangle.CATPart'.
  Release it.
  5. Open for edit 'Viewer.CATProduct'
  6. Do a modification of the released
  part 'Rectangle.CATPart'. Say 'no' to the COOF
  message. (part is dirty)
  7. Check in the CATProduct 'Viewer'. (say Ok to
  the message about the dirty part)
  Problem : The cgr created for the
  CATProduct 'Viewer' shows the modification in
  the 'Rectangle' part. (this can be checked by
  opening the cgr in CATIA or by using the
  Smarteam viewer)
  It's not consistent with the CATProduct in the vault
  .
  

Problem conclusion

• THIS PROBLEM IS PERMANENT RESTRICTION IN
  CATIA
  Incident Diagnosis
  Product cgr file created is not consistent with data
  in the vault
  Restriction Explanation
  In the scenario, one Part is modified-ReadOnly. We
  can't unload it and can't save it. The cgr file is
  generated from the CATIA product in session.
  Therefore it contains the part modification.
  When doing the smarteam/save on the product, the
  user gets a warning message telling him that a Part
  is modified in ReadOnly status. Through the
  message, we recommend to solve this problem
  before saving the assembly. This is the correct way
  to proceed.
  By-Pass
  1. Cancel the save
  2. Solve the Modified ReadOnly problem (or
  CheckOut/New Release on the part)
  3. Save again the assembly
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels