| |
Removing
the SAS/SATA controller
To remove the
SAS/SATA controller:
- Turn off
the HMC and peripheral devices and disconnect all power cords.
- Unlock and
remove the side cover. (Refer to Removing
and Replacing the Cover.)
- Squeeze the
tabs on both sides of the connector on the signal cable and remove
the cable from the SAS/SATA controller.
- Carefully
disengage the tabs on each side of the SAS/SATA controller connector
and the front of the SAS/SATA controller from the plastic standoff.
- Grasp the
edges of the SAS/SATA controller and pull it out of the connector.
If the standoff comes away from the system board with the controller,
gently pull it out of the controller and push it back into the
hole on the system board.
- If you are
instructed to return the SAS/SATA controller, follow all packaging
instructions, and use any packaging materials supplied to you
for shipping.
|
