|
|
|
Removing
the hard drive
To remove the
hard disk drive:
- Make sure
the HMC cover is in place and fully closed.
Attention: To avoid damage to the hard disk drive
connectors, make sure that the HMC cover is in place and fully
closed whenever you install or remove a hard disk drive.
- Turn off
the HMC and peripheral devices and disconnect all power cords.
Start
the video ...
- Remove the
filler panel from the bay.
Note: To make sure that there is adequate system
cooling, do not operate the HMC for more than two minutes without
either a hard disk drive or a filler panel installed in each bay.
- Pull the
loops of the drive tray toward each other and pull the tray out
of the bay.
|
|
|
|
|
|