After you answer questions and provide information about
your environment, the wizard generates a custom configuration procedure.
The following set of steps represents all possible configuration steps.
The instructions that you generate might include or exclude specific
steps based on your wizard selections.
About this task
After you create a static or dynamic cluster, you can create
an additional horizontal cluster node to handle failover requests.
When creating an additional horizontal cluster node on another server,
run the Configuration Wizard from that server.Procedure
- Manual Step:
Install portal binary files on the server where you plan to add a
node to your cluster.
- Condition
- None
- ConfigEngine task
- None
- Manual Step:
Install profile templates.
- Condition
- None
- ConfigEngine task
- None
- Manual Step:
Copy the database drivers from the primary node to the additional
node.
- Condition
- None
- ConfigEngine task
- None
- Manual Step:
Verify that the portal node and deployment manager system clocks are
within 5 minutes of each other.
- Condition
- Remote deployment manager
- ConfigEngine task
- None
- Create the
profile for the secondary portal node.
- Condition
- none
- ConfigEngine task
- none
- Federate the
node. This node
then becomes a managed node in the deployment manager cell.
- Condition
- none
- ConfigEngine task
- add-node
- Configure
the dynamic cluster node. Add a nodegroup and add nodes
to the nodegroup.
- Condition
- Dynamic cluster
- ConfigEngine task
- dynamic-cluster-create-nodegroup
- dynamic-cluster-add-node-to-nodegroup
- Add a secondary
node to the cluster.
- Condition
- Static cluster
- ConfigEngine task
- cluster-node-config-cluster-setup-additional
- Add a secondary
node to the cluster.
- Condition
- Dynamic cluster
- ConfigEngine task
- dynamic-cluster-setup-additional
- Start the portal server.
- Condition
- None
- ConfigEngine task
- start-portal-server