Kursen har inget datum. Ring vår kursbokning 077 186 10 37 för information om en privat utbildning.
Översikt
| Kurskod | XTR303SE | Leveranstyp | Classroom
(Hands-on labs) |
|---|---|---|---|
| Kurslängd | 2.0 dagar | Kurstyp | |
| Listpris | Set by Partner |
The IBM BladeCenter Fundamentals course provides a detailed introduction and overview of the IBM BladeCenter. Major topics covered include the BladeCenter chassis components and infrastructure, management interface, blade servers, and I/O modules.
Each major lecture group is followed by a hands-on lab exercise, including chassis configuration and management, blade server control and I/O module management and control. The final lab provides a step-by-step guide to implementing diskless blade boot-from-SAN.
Visa den här kursen i andra länder
Roadmaps:
Målgrupp
Enrollment in this course is not restricted. However, typical students taking this course include technical IBM personnel from the FTSS, ATS, and Techline organizations as well as business partner technical personnel involved with planning, installation, configuration, and management of the IBM BladeCenter.
Förkunskaper
The following course is required prior to this course:
- System x Technical Principles (Enhanced) (XTR11ASE)
Mål
- Describe each major BladeCenter chassis component and supporting infrastructure
- Perform chassis management through the Advanced Management Module
- Explain the major blade server components and interfaces to the BladeCenter
- Describe the Fibre Channel and Ethernet I/O module functions and interfaces
- Perform command line and Web interface management of Ethernet I/O modules
- Understand BladeCenter installation recommendations and practices
- Perform basic problem diagnoses and resolution
Nyckelområden
Day 1
- (00:30) Course administration and introduction
- (01:30) Unit 1: IBM BladeCenter introduction
- (02:00) Unit 2: Systems management with Advanced Management Module
- (00:15) Exercise 1: Identifying the BladeCenter environment
- (01:00) Exercise 2: Systems management with Advanced Management Module
- (01:15) Unit 3: Blade server technology
Day 2
- (01:30) Unit 4: Ethernet connectivity and options
- (00:20) Exercise 3: BNT 2-3Gb Ethernet switch module
- (00:20) Exercise 4: Cisco IGESM
- (01:30) Unit 5: Storage connectivity and options
- (01:15) Exercise 5: Preparing to boot the blade from a SAN
- (02:00) Unit 6: Installation and troubleshooting overview